Building my Electric Guitar

Building My Electric Guitar - Routing The Body Edges

Now that I'm comfortable with the neck pocket area, its now time to route the edges of the guitar body. I used a 1/4" rounding bit in the router. Also, make sure the piece of wood you are routing is firmly clamped to the table.


Build my electric guitar Mahogany wood


Its important to run the router in the proper direction around the outer edge of the Electric Guitar body.. Since most routers spin the bit in a clockwise direction, you will need to move the router in a counterclockwise direction.

As you can see in the photo below, reinforcing the neck pocket area worked out fine.


Building my Electric Guitar

Next page: Sanding The Body













Copyright © 2019 All Rights Reserved.
Joomla! is Free Software released under the GNU/GPL License.